FunctionPart
Power input connector1
Network connector (Ethernet)2
UniNet-9 connectors
Note:
Termination plugs must be connected to the connectors that are not in use.
3
Other connectors are for use by authorized service engineers only.
NOTICE
Misuse of UniNet-9 connectors. The UniNet-9 connectors at the
rear panel should not be mistaken for Firewire connectors. Do not
connect any external equipment to the UniNet-9 connectors. Do
not disconnect or move the UniNet-9 bus cable.
70 ÄKTA avant Operating Instructions 29101556 AB
4 Installation
4.2 Hardware installation
4.2.2 Connect the system units
To Next Page
Loading...
