GE AKTA avant - Page 71

Connect power to the ÄKTA
avant instrument
Follow the instructions to connect power to the ÄKTA avant instrument.
ActionStep
Select the correct power cord to be used. Each instrument is delivered with
2 alternative power cords:
1
•
Power cord with US-plug, 2 m
•
Power cord with EU-plug, 2 m
Discard the unused power cord.
Connect the power cord to the Power input connector on the back of the
instrument and to a grounded wall outlet 100 to 240 VAC , 50 to 60 Hz.
2
Attach the power cord to the rear of the instrument using the cable clip.3
Connect power to computer
equipment
Follow the manufacturer's instructions to connect power to the computer, monitor and
local printer (if used).
ÄKTA avant Operating Instructions 29101556 AB 71
4 Installation
4.2 Hardware installation
4.2.2 Connect the system units