Connect to network
Follow the instructions to make network connections.
ActionStep
Connect a network cable between the network connector (Ethernet) on the
back of the instrument and the computer network card dedicated to ÄKTA.
The illustration shows the symbol of the Ethernet connector.
1
If the computer is to be connected to an external network, connect a network
cable between the main network card of the computer and a network wall
outlet.
Note:
If the computer has not been supplied by GE and if network configuration is
to be used, see UNICORN Administration and Technical Manual for further
information on network settings.
2
72 ÄKTA avant Operating Instructions 29101556 AB
4 Installation
4.2 Hardware installation
4.2.2 Connect the system units
To Next Page
Loading...
