To Next Page

To Previous Page

Parts lists, drawings and replacement

2001989-203C ApexPro™ Telemetry 7-5

Fan filter

1. Turn the latch securing the front service door on the front panel of the ATS and

open the door.

203A

2. Slide the filter frame out of the service opening.

011A & 010A

3. For the 2021512-011 FRU only, remove the foam filter from the filter frame.

4. Follow the applicable instructions, depending on the FRU you are replacing.

043A & 013A

 If you are replacing the PN 2021512-011 FRU with a new PN 2021512-011

FRU, replace the foam filter only.

 If you are replacing the PN 2021512-011 FRU with a new PN 2021512-022

FRU, discard the PN 2021512-011 FRU and install the PN 2021512-022

FRU.

5. Reverse the steps in this procedure to install the fan filter.

Drive bay

door latch

PN 2021512-011

PN 2021512-022

PN 2021512-011: Frame and filter are separate;

only the filter is supplied in the FRU

PN 2021512-022: Frame and

filter are integrated in the FRU

Brand

Model

ApexPro

GE ApexPro Service Manual

Other manuals for GE ApexPro