GE ApexPro

To Next Page

To Previous Page

Checkout

2001989-203C ApexPro™ Telemetry 8-3

 Perform ApexPro Channelized Telemetry System receiver check. See ApexPro

Channelized Telemetry System receiver check on page 8-15.

 Perform power fail alarm verification test (power). See Power fail alarm

verification test (power) on page 8-16.

 Perform ground continuity test. See Ground continuity test on page 8-13.

 Perform ground (earth) wire leakage current tests. See Ground (earth) wire

leakage current tests on page 8-16.

 Perform enclosure (chassis) leakage current tests. See Enclosure (chassis)

leakage current test on page 8-17.

 Verify that the Remote Service agent is enabled. See Enable the Remote Service

agent on page 5-12.

Preventive maintenance checkout procedures

Use the following checklist to ensure completion of all preventive maintenance and

checkout procedures.

 Perform general visual inspection. See General inspection on page 8-7.

 Clean external surfaces. See External surfaces on page 8-9.

 Inspect power supply. See Check for power supply problems on page 6-3.

 Clean internal components. See Internal components on page 8-11.

 Clean fans. See Fans and filters on page 8-11.

 Clean filters. See Fans and filters on page 8-11.

 Perform installation check. See Perform installation check on page 5-16.

 Perform disk check. See Disk check on page 6-17.