4-4 ApexPro™ Telemetry 2001989-203C
Service interfaces
7. Select Use the following IP address.
8. Type IP address, subnet mask and default gateway values matching the Unity
Network IX network domain for the ATS. For example:
IP Address: 192.168.x.x
Netmask: 255.255.0.0
9. Select OK.
10. Select OK.
11. For Windows 2000, instead of restarting the service laptop, you can select Start >
Settings > Network and Dial-up Connections, right-click on Local Area
Connection, select Disable and then right-click again and select Enable.
Windows XP
1. From the Windows taskbar, select Start > Control Panel > Network
Connections.
2. Right-click Local Area Connection.
3. Select Properties.
4. Select Internet Protocol (TCP/IP).
5. Select Properties.
6. Record the current IP address and subnet mask so you can restore them later.
7. Select Use the following IP address.
8. Type IP address, subnet mask and default gateway values matching the Unity
Network IX network domain for the ATS. For example:
IP Address: 192.168.x.x
Netmask: 255.255.0.0
9. Select OK.
10. Select OK.
11. For Windows XP, instead of restarting the service laptop, you can select Start >
Control Panel > Network Connections, right-click on Local Area Connection,
select Disable and then right-click again and select Enable.
Configure the Internet browser
The FE's Internet browser is configured to use GE specific configuration script to
access GE internal websites. The following steps must be performed to gain remote
access to ATS within the hospital intranet (ATS Webmin / ATS Desktop):
1. On the Desktop, right-click on the Internet Explorer icon and select Properties.
2. Select the Connections tab.
3. Select LAN settings.
4. Check Automatically detect settings.
To Next Page
Loading...
Need help?
General
