GE ApexPro Service Manual

6-8 ApexPro™ Telemetry 2001989-203C
Troubleshooting
Service status indicators
WARNING
EQUIPMENT FAILURE — Do not ignore indicated system
failures.
The ATS can fail if conditions causing system alarms are not
rectified quickly.
The ATS is equipped with system status indicators that activate whenever specific
system-critical conditions are met. Status indicator system failure alarms call
attention to critical system conditions which require immediate attention.
ATS status indicators include:
Inability to access SNMP
while server is running
SNMP card failure Replace SNMP card See SNMP boards on page 7-11.
Incorrectly connected SNMP
cable
Verify and/or re-install cable N/A
Misconfigured IP address Reconfigure IP address
Use the ATS ping functionality to
Verify the IP address settings (if
required) on page 5-5.
N/A
Inability to read
temperature via SNMP
Temperature sensor failure Replace temperature sensor
or
View hardware environmental
parameter data via BIOS
settings on page 6-11
See Temperature sensor on page 7-
32.
System overheating Dust or debris in fans or filters Clean system See Fan filter on page 7-5.
See Drive filter on page 7-6.
System fan failure Replace fans See Chassis fan on page 7-24.
Inability to use CDROM
drive
Failure of CDROM drive Replace CD drive See CD ROM drive on page 7-22.
Loose or disconnected CDROM
drive cable
Reconnect drive cable N/A
Inability to display fan
speed, temperature and
voltage information
Failure of SNMP communication 1. Reboot the system and
wait for 5 minutes after the
3 beeps have sounded.
2. Try to read the hardware
diagnostic information
again. If the information is
not displayed, the problem
may lie in the SNMP card.
or
View hardware environmental
parameter data via BIOS
settings on page 6-11.
N/A
Symptom Possible reason Solution/course of action FRU procedure

GE ApexPro Specifications

General

Brand	GE
Model	ApexPro
Category	Medical Equipment
Language	English