Parts lists, drawings and replacement
2001989-203C ApexPro™ Telemetry 7-7
Network card
1. Complete the preparation procedures. See Field replacement preparation on page
7-3.
2. Disconnect the network cable plug from the connector at the back of the network
card.
3. Remove the chassis cover. See Chassis cover on page 7-6.
4. Remove the 3 screws securing the back of the CPU module to the chassis.
046A
5. Remove the 2 screws securing the front of the CPU module to the chassis.
048A
6. Carefully move the CPU module far enough to allow card removal.
7. Using a phillips screwdriver, remove the screw securing the network card in the
slot.
163A
8. Remove the network card from the slot.
164A
9. Reverse the steps in this procedure to install the network card.
To Next Page
Loading...
Need help?
General
