GE ApexPro

8-4 ApexPro™ Telemetry 2001989-203C
Checkout
 Inspect fans and power supply. See Fans on page 8-7.
 Inspect connectors. See Connectors on page 8-7.
 Inspect cable insulation. See Cable insulation on page 8-8.
 Clean external surfaces. See External surfaces on page 8-9.
 Clean internal components. See Internal components on page 8-11.
 Clean fans. See Fans and filters on page 8-11.
 Clean filters. See Fans and filters on page 8-11.
 Perform installation check. See Perform installation check on page 5-16.
 Perform disk check, if needed. See Disk check on page 6-17.
 Perform ApexPro Channelized Telemetry System receiver check. See ApexPro
Channelized Telemetry System receiver check on page 8-15.
 Perform power fail alarm verification test (power). See Power fail alarm
verification test (power) on page 8-16.
 Perform ground continuity test. See Ground continuity test on page 8-13.
 Perform ground (earth) wire leakage current tests. See Ground (earth) wire
leakage current tests on page 8-16.
 Perform enclosure (chassis) leakage current tests. See Enclosure (chassis)
leakage current test on page 8-17.
 Verify that the Remote Service agent is enabled. See Enable the Remote Service
agent on page 5-12.
Maintenance
Recommended tools
 Leakage tester
 Digital multimeter
 ESD mat and wrist strap
 Standard hand tools