GE ApexPro Service Manual

5-12 ApexPro™ Telemetry 2001989-203C
Configuration
5. Select Save to apply the configuration setting changes.
Enable the Remote Service agent
The ATS is factory-configured with the Remote Service agent disabled. After an FE
has configured your ATS for remote serviceability, this option must be enabled for
use. To enable or disable the Remote Service agent, perform the following steps.
1. Log onto the Webmin service interface on page 4-7.
2. Select the Configuration tab.
3. Select Remote Service > Control.
125A
4. On the Remote Service Controls screen, select the appropriate option in the New
State field:
 To enable the Remote Service Agent, select Enable.
Remote Service Configuration
Parameter Value Notes
System ID Identifies the system to the GE
backoffice servers.
These values are read-only
and are unique.
Serial Number Identifies the unit and is set at the
time of manufacture.
Enterprise URL If required, designate the address
of the GE backoffice servers
required to communicate with the
Remote Service agent.
This address is typically
preconfigured to connect to the
Remote Back Office, but it can
be edited to suit customer
requirements.
Enterprise Tunnel
URL
If required, designate the address
of the GE backoffice servers
required to communicate with the
tunneling agent.
Protocol Identifies the protocol used to
communicate with the enterprise
servers.
This field is read-only and
cannot be changed.

GE ApexPro Specifications

General

Brand	GE
Model	ApexPro
Category	Medical Equipment
Language	English