To Next Page

To Previous Page

2-16 ApexPro™ Telemetry 2001989-203C

Equipment overview

NOTE

This is different from ApexPro in that ApexPro admit requests are sent to a

selected tower, not a specific receiver.

NOTE

The master tower cycles CDT–LAN admissions through all available receivers,

so the admit/discharge/admit sequence does not exclusively use the same

receiver over and over. This is done because, if a particular receiver

malfunctions, and the user discharges and then readmits a patient, the next admit

will go to a different receiver.

ApexPro admit request forwarding

If the admit request was determined to be of ApexPro telemetry type, the admit

request is sent to the selected ApexPro tower, the tower assigns the admit to an

available receiver and the admit is processed.

NOTE

This is different from CDT-LAN. CDT-LAN admit requests are sent to a selected

receiver, not a specific tower.

NOTE

The master tower cycles ApexPro admissions through all available towers, and

subsequently, the towers themselves cycle admissions through all available

receivers. This is done so the admit/discharge/admit sequence does not

exclusively use the same receiver over and over. This is done because, if a

particular receiver malfunctions, and the user discharges and then readmits a

patient, the next admit will go to a different receiver, potentially on a different

tower.

Service utilities

See the ApexPro utilities on page 4-13 for detailed information about using ATS

service utilities.

GE ApexPro Service Manual

Other manuals for GE ApexPro