GE AutoSigma 3000 DL - Customising the Operating Mode

H
Note:
Whilst selecting locations steps 4 and 5 you may move
to another fi le simply by pressing the FILE button and
incrementing to the required fi le. Press FILE again to
revert to location selection.
– Alternatively if you wish to clear this location contin-
ue from step 4.
– Long press C will clear the location and the display
will show:
This indicates that fi le XX location FF is empty and
can now accept a logged reading.
– To log to this location, press FILE again to revert to
location selection.
5.8 Customising the operating
mode
The operating mode of the AutoSigma 3000 DL can
be customised to suit a particular measurement pro-
cedure. Menu items can be selected and given a value
or a mode, a complete menu can then be stored, this
customised menu can then be recalled when required.
The AutoSigma 3000 DL may be set to User mode
where the menu cannot be selected or changed, or
Supervisor mode where the menu is fully functional.
This is achieved by sending instructions from a PC to
the AutoSigma 3000 DL.
H
Note:
When in User mode the reset switch on facility is not
available.
Customising the operating mode
Operation
5 - 14
Issue 04, 06/2007 AutoSigma 3000