Sending serial data to an external device
6.2 Sending serial data to an
external device
Connect the external equipment to the instrument via
the correct interface cable and switch it on.
The AutoSigma 3000 DL will recognise the connection
and change the use of the SEND button from internal
data logging to external serial data transfer.
Individual fi les or the entire memory can be transmit-
ted, but only fi les containing stored data will be trans-
ferred i.e. fi le active or fi le full.
A long press on the SEND button is used to initiate
data out transfer with the File menu set to a single fi le
or ALL FILES.
H
Note:
For correct handling of transmitted data PCs and print-
ers should be set to Xon / Xoff protocol.
Sending a single fi le
With the instrument in the Measurement mode:
Step Key Display
1
Open the fi le menu.
2
If fi le to be transferred is
not current (i.e. the dis-
played one), select the
fi le required (e.g. 2).
3
Transfer the fi le with
a long press; after the
press the display will in-
dicate the transfer.
When transmission is complete the display will revert
to the fi le selection.
H
Note:
To terminate a data transfer when in progress press
SEND. Display will respond for a short period with
External data handling devices
AutoSigma 3000 Issue 04, 06/2007 6 - 3
To Next Page
Loading...
