Storing a customised mode
– In order to store a customised operating mode, se-
lect MENU then select STORE with the arrow keys.
– In the SET mode, select the required store location
(1 to 10) with the arrow keys and apply a long press
to SEND.
Two beeps will confi rm that the MENU SETTINGS
have been stored.
Recalling a customised mode
– To recall a customised operating mode select
RECALL from the menu with the arrow keys.
– In the SET mode select the required location (1 to
10) with the arrow keys and apply a long press to
SEND.
Two beeps will confi rm that the MENU SETTINGS
have been recalled.
Setting the operating mode to User or
Supervisor
The AutoSigma 3000 DL normally works in the Su-
pervisor mode where the menu is fully functional, it is
supplied set to this mode, the instrument may also be
set to User mode where the menu cannot be selected
or changed.
To change between the User or Supervisor mode the
unit should be on and in the read mode and connected
to a suitable PC, via cable part no 33A146 (PC serial
cable).
H
Note:
To access the AutoSigma 3000 DL using a PC running
windows go into “Terminal” program (usually in acces-
sories group) choose “Settings”; “Communications” in
the comms box select the COM port connected to the
AutoSigma 3000 DL (COM1 or COM2) then set baud
rate 1200; data bits 8; stop bits 1; parity none; fl ow
control; Xon/Xoff; Leave “parity check” and “carrier de-
tect” unselected.
Customising the operating mode
Operation
AutoSigma 3000 Issue 04, 06/2007 5 - 15
To Next Page
Loading...
