106 GE INFORMATION D20MX HARDWARE USER’S MANUAL
APPENDIX D: USING CONFIGPRO WITH D20MX
3.2. Select a project location to which the configuration file is to be restored.
Note: The D20MX factory default configuration files are ConfigPro 5 based. If
using ConfigPro 6 or 7, when prompted to upgrade, select Yes. By restoring the
factory D20MX device to the same project location as the renamed D20
[D20MX device] in step 1.3, this will eliminate the need to copy the SAN
firmware to make it available in the firmware library - as described in step 3.3.
If a message indicates that a nested loop [project] will be created, choose a
different Project directory as required: e.g., C: drive in the screen capture that
follows.
To Next Page
Loading...
