GE D20MX - Transferring D20 configurations

118 GE INFORMATION D20MX HARDWARE USER’S MANUAL
APPENDIX D: USING CONFIGPRO WITH D20MX
5.4.11.Open up the device and go to the Wesmaint II+ application to compare
the RADIUS Role [RADR] tables in the factory default D20MX device with
that in the newly modified D20MX device. Compare the first two columns
[Role ID and Role Name] as shown below to confirm the export and
import was successful. If not, repeat the export/import process.
6. Generate the device configuration, after a configuration has been properly
configured.
Result: If there are no errors or warnings, the red dot on the device should not appear
and the generated device is ready to be downloaded into the D20MX RTU.
7. The transfer of a D20 configuration into a D20MX configuration is complete.
Configuration file in project directory
NOTE
In step 5.4.10, a D20MXDEVICE.SHX file was created after generating the tables of this
D20MX device created. This file can be found within the device directory in windows
explorer.