114 GE INFORMATION D20MX HARDWARE USER’S MANUAL
APPENDIX D: USING CONFIGPRO WITH D20MX
5.3.5. While in the D20MX device created in step 1, double-click and go to the
System Point Database tab which contains the Wesmaint II+ application.
Right-click on the RADIUS Role Table [B014RADR] and import the
B014RADR settings previously exported. Select the B014RADR.CSV file
and click Select.
5.4. Configure the IP Redundancy Monitor [B152] application.
Note: If the IP redundancy [B152] application in the DCA is enabled, its pseudo
point descriptions must be correctly set. Complete the following steps to
ensure this.
5.4.1. Use the D20MX factory default configuration as reference.
To Next Page
Loading...
