120 GE INFORMATION D20MX INSTRUCTION MANUAL
APPENDIX D: USING CONFIGPRO WITH D20MX
3.1.3. Navigate to the factory default configuration files which were staged
previously.
The listed factory-default configuration files with a .zip extension were
built with ConfigPro.
3.2. Select a project location to which the configuration file is to be restored.
Note: The D20MX factory default configuration files are ConfigPro 5 based. If
using ConfigPro 6 or 7, when prompted to upgrade, select Yes.
If a message indicates that a nested loop [project] is to be created, choose a
different Project directory as required: e.g., C: drive in the screen capture that
follows.
To Next Page
Loading...
