To Next Page

To Previous Page

APPENDIX D: USING CONFIGPRO WITH D20MX

D20MX INSTRUCTION MANUAL GE INFORMATION 133

2.5.5. Change the baud rate to match 57600 by selecting the Software

Transmit and Software Receive options and then clicking OK.

2.5.6. Reconnect to and login to the D20MX. See step 2.3 [Connect to the

D20MX device].

2.5.7. Download [sync] the configuration from ConfigPro to the D20MX by

pressing the F7 key.

Result: The Download Configuration File progress bar appears.

2.6. Restart the D20MX device when the download is complete by clicking Boot.

NOTE

Booting the D20MX resets it to its previous baud rate. If the baud rate in the

D20MX is not the same as that in the communication properties, the command

prompt shows the following characters.

If this is the case, change the ConfigPro communication properties to match

the baud rate of the D20MX.

Other manuals for GE D20MX

Questions and Answers:

Need help?

Do you have a question about the GE D20MX and is the answer not in the manual?

General