80 GE INFORMATION D20MX INSTRUCTION MANUAL
CHAPTER 5: CONFIGURING THE SOFTWARE
10.7. Compare the first column of the Access Flags sub-table (RADIUS Role Table >
Application Control) to the following figure to confirm that the import was
successful:
10.8. Click OK, OK and Close.
Result: The WESMAINT II+ table editor closes.
11. If the D20 configuration being transferred is LAN-based, import the LAN Redundancy
Manager point descriptors:
11.1. Click the Project tab of the original D20 or D200 device configuration.
11.2. Double-click the D20MX device.
Result: The Application List popup appears.
11.3. Double-click the System Point Database application.
Result: The System Point Database Properties dialog appears.
11.4. Select LAN Redundancy Manager and click Descriptors.
Result: The Point Descriptors dialog appears.
11.5. Click on the Import button.
Result: The Import Point Descriptors dialog appears.
11.6. Click OK.
Result: The Browse For Folder dialog appears.
11.7. Navigate to the DVD/CD drive or the ISO Image sub-folder nested two levels
into the folder extracted from the D20MX Documentation CD zip file. Then
navigate to Configuration Files > DefaultPointDescriptions > B119-1N LAN
Redundancy Manager and click OK.
Result: The Point Descriptors dialog appears.
To Next Page
Loading...
