GE D20MX - Page 81

CHAPTER 5: CONFIGURING THE SOFTWARE
D20MX INSTRUCTION MANUAL GE INFORMATION 81
11.8. Confirm the point descriptors are as shown below.
11.9. Click OK, OK and Close.
Result: The main project window appears.
12. Optionally, update the RADIUS and SYSLOG settings in B014-1N (WESMAINT II+):
12.1. Click the Project tab of the original D20 or D200 device configuration.
12.2. Double-click the D20MX device.
Result: The Application List popup appears.
12.3. Double-click the WESMAINT II+ application.
Result: The WESMAINT II+ table icon set appears.
12.4. Update the new tables: Remote RADIUS Servers Table, Remote Syslog Servers
Table, TLS Auth Info Table, TLS CA Info Table, First PEM File Table, Second PEM
File Table and Login Warning Banner Table, referring to the B014-1NCG
WESMAINT II+ configuration guide.
13. If the configuration being transferred is LAN-based, generate the iSCS Configuration
for the Project:
13.1. Click the Project tab of the original D20 or D200 device configuration.
13.2. Click: the D20MX device.
13.3. Click the ribbon Configure group > iSCS > Generate.
13.4. Confirm that there are zero errors in the Device Log; any Warnings are
acceptable.
14. If the configuration being transferred is not LAN-based, generate the configuration for
the device:
14.1. Click the Project tab of the original D20 or D200 device configuration.
14.2. Click the D20MX device.
14.3. Click the ribbon Configure group > Configuration > Generate.
14.4. Confirm that there are zero errors in the Device Log; any Warnings are
acceptable.
15. Review warnings:
15.1. Click the Project tab of the original D20 or D200 device configuration.
15.2. Click the D20MX device.
15.3. Click the ribbon Configure group > Draw > select Output Window.
Result: The Device Log window appears.