Programming Site Data 1-43
March 2008
Entering Global System
Data (cont.)
6. Press [F1]-[F4] to select the desired number of Decimal Digits
(digits to the right of the decimal point) in the volumetric flow rate
display.
7. Use the [←], [→] and
[F1]-[F4] keys to select the desired Totalizer
Units.
Note: The option bar above shows English units. If Metric units are
specified in the
GLOBL menu, these will appear instead.
The abbreviations and definitions of all the available totalizer units
are shown in Table 1-16 below. The choices shown on the option bar
in the prompt screen above are determined by the selections made at
the previous System Units prompt screen.
8. Press
[F1]-[F4] to select the desired number of Decimal Digits
(digits to the right of the decimal point) in the totalized flow
display.
If you did not select the Energy Option in the
Channel SYSTEM option,
the meter now returns to the initial
SYSTEM prompt. But if you
selected the Energy Option, the following additional prompts appear.
Table 1-16: Totalizer Units Options
English Totalizer Units Metric Totalizer Units
Gal - U.S. Gallons L - Liters
MGAL - Mega U.S. gallons ML - Megaliters
ft
3
- Cubic Feet m
3
- Cubic Meters
Mft
3
- Mega Cubic Feet Mm
3
- Mega Cubic Meters
BBL - Barrels BBL - Barrels
MBBL - Megabarrels MBBL - Megabarrels
Acre-inches
Acre-feet
To Next Page
Loading...
Need help?
General
