GE EntelliGuard G - Circuit Breaker - Key Interlock Facility; Table 4.14. Power Rated (4 NO;4 NC) + Low Signal (Hi-Fi) (4 NO;4 NC) (Ref Drawing 10099234

DET-653C EntelliGuard
®
G Circuit Breaker Application Guide
24-May-12 Section 4. Accessories
©2012 General Electric All Rights Reserved
44
Table 4.14. Power Rated (4NO/4NC) + Low Signal (Hi-Fi) (4NO/4NC) (Ref Drawing 10099234)
Normally Open
Normally Closed
Switch Contact
Secondary
Disconnect
Connector
Switch Contact
Secondary
Disconnect
Connector
1
A25
PL1
3
A19
PL5
Power
Rated
2
A24
4
A18
5
A23
7
A17
6
A22
8
A16
9
A21
11
A15
10
A20
12
A14
13
B26
PL2
15
B13
PL6
14
B25
16
B12
17
B24
PL4
19
B11
PL8
Hi-Fi
18
B23
20
B10
21
B22
PL3
23
B9
PL7
22
B21
24
B8
25
B20
27
B7
26
B19
28
B6
29
B18
31
B5
30
B17
32
B4
• 15A max. current, 440V max.
Circuit Breaker - Key Interlock Facility
This option supplies factory-installed key interlock
mounting provisions (baseplates and mechanism) on the
front of the breaker fascia. Key interlocks ensure that a
circuit breaker cannot be closed unless the dedicated key
has been inserted and secured within the lock. Circuit
breakers accept ready-to-fit interlocking device kits such
as Castell, Ronis, Kirk and Profalux for installation
between related, separate circuit breakers. NOTE: Locks
and keys are not supplied by GE. Please order separately
from your local supplier (Table 4.15 and Figs. 4.3 and 4.4).
Table 4.15. Key Interlocks and Door Interlocks
Description
Catalog Number
Baseplate and mechanism for Ronis locks
(breaker mounted)
GBRONR
Baseplate and mechanism for Kirk Key locks
(breaker mounted)
GBKRKR
Mechanism for Ronis key cassette interlock
(cassette mounted)
GCRONR
Mechanism for Kirk key cassette interlock
(cassette mounted)
GCKRKR
Door interlock (left side)
GLHD
Door interlock (right side)
GRHD
• Kirk Keys for Fixed Breaker: CN22. Kirk Keys for Cassette:
KCAMXXX105 (Extended), KCAMXXX11S (Withdrawn). S
indicates that the key designation (A,B, etc.) is to be
stamped on the lock and the key.
• Ronis: Type 1104B lock with standard key, 1/4 in. turn to
trap the key, compulsory spindle size.
• For drawout breaker applications, key interlocks can be
mounted in the cassette.
Figure 4.3. Breaker-Mounted Key Interlock
A
A Key interlock mounting locations
Figure 4.4. Cassette-Mounted Key Interlock
A
A Key interlock mounting locations