GE Giraffe - 4.2 Service Screen

Girae Warmer 3-14
Screen
Step
Description
2
To remove a bedside panel, lower the panel
and hold it parallel with the oor. Press the
side panel release button (arrow) with one
hand and remove the panel.
To replace a bedside panel, insert the panel
into the xed end pin rst. Then press the
side panel release button in with one hand,
place the panel in position and release the
pin.
3
A tubing management front and rear
bedside panel aids in routing tubing to
patients receiving therapy in warmer beds.
The various size holes in the panel can
accommodate large diameter tubes, such
as ventilator tubes or the ber optic cables
or smaller diameter I.V. tubes and ECG leads.
HFOV side panels are also available.
WARNING:
The Panda iRes Warmer and Girae Warmer bedside panels are dierent heights. Use only
the Panda iRes Warmer bedside panels on the Panda iRes Warmer.
Tilting the bed
Illustration
Step
Description
1
The bed tilts twelve degrees to allow feet
up or head up positioning of the baby. The
tilt release is located underneath the foot of
the bed. Grasp both the handle and metal
release in one hand and squeeze. Push down
or lift up on the foot of the bed to the desired
position. Letting go of the release at any
point on the tilt path locks the bed in that
position.