GE HEALTHCARE
DIRECTION 5461425-8EN, REVISION 6 BRIVO XR118 SERVICE MANUAL
Chapter 11 - - Master Interconnect System Map Page 249
Chapter 11 - Master Interconnect System Map
Section 1.0
Scope
This section describes the MIS (Master Interconnection System) map.
Section 2.0
Symbols/Conventions
The equipment outlines on the map identify where connections are made. These outlines are usually major assemblies. Internal divisions show
modules/circuit boards. These components are identified using the component location codes defined for each product. (If you are unfamiliar with
these codes refer to the schematics direction for any major product. It is worth your effort to learn these codes.)
MIS runs are identified by lines between connection points, with the MIS number in an oval at each end of the line.
To Next Page
Loading...
