GE Healthcare Brivo XR118 - Section 5.0 AP Assembly Preparation; 5.1 AP assembly connection

GE HEALTHCARE
DIRECTION 5461425-8EN, REVISION 6 BRIVO XR118 SERVICE MANUAL
Page 56 Section 5.0 - AP Assembly Preparation
Section 5.0
AP Assembly Preparation
Note: Because wireless performance will be tested in AP Assembly Installation on page 122 and AP
Assembly location may be changed, please do not install AP Assembly in this step, just place
it at Default location or Adjusting range according to room layout.
5.1 AP assembly connection
5.1.1 Unpacking
Figure 5-8 Unpack AP assembly & PoE ethernet cable
5.1.2 Connection
1.) Take out wireless AP and PoE Ethernet Cable.
2.) Connect the PoE ethernet cable from Dock’s ethernet PoE port to AP which will be located in
the exam room.
Note: The end which has USB connector should be used to connect AP.
3.) The wireless AP will automatically boot up if the dock is powered on and image workstation is
inserted into dock.
Access Point
PoE Cable