EasyManua.ls Logo

GE Healthcare Brivo XR118 - Chapter 3 - Installation Guide; Section 1.0 Steps for system installation

GE Healthcare Brivo XR118
318 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
GE HEALTHCARE
DIRECTION 5461425-8EN, REVISION 6 BRIVO XR118 SERVICE MANUAL
Chapter 3 - - Installation Guide Page 37
Chapter 3 - Installation Guide
The primary tasks are designed to be performed in sequence. Follow the sequence of tasks
described for each primary task in Chapter 3 - that follow.
There are marks on the installation steps which are only suitable for fixed RAD system.
Section 1.0
Steps for system installation
1 Complete Pre-Installation Checklist People Required: 1 Minutes to Complete: 10
Fill out the Pre-Installation Checklist to confirm completion of pre-install activities before beginning the
installation process.
2 Target System Identification And Check People Required: 1 Minutes to Complete: 30
Identify and Check Target System
3 Receive and Inventory System People Required: 1 Minutes to Complete: 5
Inventory equipment & report discrepancies immediately.
Collect Product Locator Cards and store in a secure location.
Plan route and transport equipment to room.
4 Control Room People Required: 1 Minutes to Complete: 5
Control Room Placement
5 MIS Cable Connections People Required: 1 Minutes to Complete: 5
Connect MIS Cable
6 AP Assembly Preparation (Fixed RAD system only) People Required: 1 Minutes to Complete: 5
* AP Connection and Placement
7 Detector Installation People Required: 1 Minutes to Complete: 5
Table Upgrade
Wallstand Upgrade
8 System Power Up People Required: 1 Minutes to Complete: 5
System power up
9 Software Configuration People Required: 1 Minutes to Complete: 30
System Software Configuration (site, general, options, upgrade configuration, in-house service, PNF,
HIPAA, monitor setting, OM CBT,DICOM servers, bar code reader, insite.)
AP Configuration
10 Detector Association People Required: 1 Minutes to Complete: 5
Detector Registration
11 AP Assembly Installation People Required: 1 Minutes to Complete: 20
12 Calibration People Required: 1 Minutes to Complete: 20
Complete System Calibration: Detector Size Cal, Detector Cal, PACS/Image Display Test Image
13 QAP People Required: 1 Minutes to Complete: 15
Perform QAP
14 Function Check People Required: 1 Minutes to Complete: 50

Table of Contents

Related product manuals