GE HEALTHCARE
DIRECTION 5461425-8EN, REVISION 6 BRIVO XR118 SERVICE MANUAL
Chapter 2 - - Before You Begin Page 35
Section 3.0
On-Site Requirements
3.1 Tools and Test Equipment
There are no additional tools and test equipment besides the standard service representative tool
kit which must be available before installing the Brivo XR118 System as below.
• Common service tools
• Screwdriver: T10
3.2 Documentation
Directions are necessary for correct installation of the Brivo XR118 System. Procedures from each
document will be used and reflect the latest information available at this time.
Not all procedures in this manual apply to all sites. Before you begin installation, cross out the
procedures that do not apply to your site.
Section 4.0
Description of System
Figure 2-1 Basic Configuration - Fixed RAD
To Next Page
Loading...
