GE Healthcare Brivo XR118 - Page 81

GE HEALTHCARE
DIRECTION 5461425-8EN, REVISION 6 BRIVO XR118 SERVICE MANUAL
Chapter 5 - - Installation & Configuration Page 81
1.) Select Product Network Filter from the Configuration menu.
2.) Select the [Expert] Tab.
3.) For TVA/RCOC support, do the following:
a.) Port 5800
I.) Enter the Port number 5800.
II.) Choose tcp from the Protocol drop-down list.
III.) Enter 150.2.0.0/255.255.0.0 as the Allowed IP's.
IV.) Click on [Add.]
b.) Port 5900
I.) Enter the Port number 5900.
II.) Choose tcp from the Protocol drop-down list.
III.) Enter 150.2.0.0/255.255.0.0 as the Allowed IP's.
IV.) Click on [Add.]
4.) Click on [Apply].
9.6.3.2 System Installation
1.) The “Default” configuration for the firewall should be “On”. If “Off” is selected, set it to “On” and
“Apply”.
2.) Remaining options should be remain as default values, unless otherwise instructed by InSite.