GE Healthcare Brivo XR118 - Page 88

GE HEALTHCARE
DIRECTION 5461425-8EN, REVISION 6 BRIVO XR118 SERVICE MANUAL
Page 88 Section 9.0 - System Configuration
9.11 Some Recommended Printer Configurations
Note: For Brivo XR118, only integer value for the Printer Pixel Size is accepted. Please round this value
to the nearest integer.
9.11.1 Agfa Drystar 3000 Printer
Table 12-13 Agfa Drystar 3000 Printer
TAB Attribute Value Comments
Printer DICOM Printer Label DRYSTAR3000 Or customers preference
Application Entry Title Enter value given by Site Network Administrator AE Titles may be site
specific, be sure to check
on-site
IPNetwork Address Enter value given by Site Network Administrator
Port Number 104 Port number may be site
specific, be sure to check
on-site
Pixel Depth 12
Printer Pixel Size (micron) 79.4
Configuration Information PERCEPTION_LUT=LINEAR (no spaces)
Density Min. = 20, Max. = 300
Magnification Type CUBIC
Smooth Factor 140
Trim NO Not Supported
Polarity NORMAL
Border Density BLACK
Empty Image Density BLACK
Printer Memory Size 40Mbytes
Layout Select the desired layouts
allowed for this printer
1:1, 1:2, 2:1, 2:2
Slide formats Not Applicable