GE Moisture Target Series 6

Chapter 2. Installation
32 Moisture Target Series 6 Hygrometer User’s Manual
[no content intended for this page]
2.6.6 Installing the DC Power Cable (cont.)
2. Strip each conductor of the DC power cable by approximately 3/8”.
3. Insert each wire into the appropriate slot (+, – and chassis) and tighten
each screw to secure them in place.
IMPORTANT: Ensure that the chassis ground connection is properly
grounded.
4. Reinsert the DC connector into the rear panel (see Figure 42).
Figure 42: Reinserting the DC Connector