GE Moisture Target Series 6 User Manual

Chapter 3. Operation and Programming
Moisture Target Series 6 Hygrometer User’s Manual 63
3.6.5 Setting Calibration Data 2
Note: If you are using a VeriDri probe, the following steps will apply. For a
standard M Series probe, see Setting Calibration Data 1 on page 60.
To view calibration data, from the Settings
Menu select Cal Data and press Enter .
The following screen appears.
Note: To access the Cal Data menu, the User
Passcode is required (see section 3.6.1 on
page 56).
Use the left and right arrow keys to select
each digit to be changed and the up and
down arrow keys to increase or decrease its
value. Once the passcode has been entered,
press Enter and the following screen
appears.
If you are using a VeriDri probe, the
FH/DPCal will be highlighted. Press
Enter . The following screen appears.
3.6.5a Selecting the Calibration Point
To select the calibration point, highlight
Select Cal Point and press Enter . The
following screen appears.
Use the left and right arrow keys to select
each digit to be changed and the up and
down arrow keys to increase or decrease its
value. Press Enter to save (or Cancel
to keep the previous value), and return to the
Edit MH/DP Cal menu.

GE Moisture Target Series 6 Specifications

General

Brand	GE
Model	Moisture Target Series 6
Category	Measuring Instruments
Language	English