GE Moisture Target Series 6 User Manual

Chapter 3. Operation and Programming
60 Moisture Target Series 6 Hygrometer User’s Manual
3.6.4 Setting Calibration Data 1
Note: If you are using a standard M Series probe, the following steps will
apply. If you are using a VeriDri probe, see Setting Calibration Data 2
on page 63.
Note: To update calibration data, from the
Settings Menu select Cal Data and press
Enter . The following screen appears.
Note: To access the Cal Data menu, the User
Passcode is required (see section 3.6.1 on
page 56).
Use the left and right arrow keys to select
each digit to be changed and the up and
down arrow keys to increase or decrease its
value. Once the passcode has been entered,
press Enter and the following screen
appears.
If you are using a standard M Series probe,
the MH/DP Cal will be highlighted. Press
Enter . The following screen appears.

GE Moisture Target Series 6 Specifications

General

Brand	GE
Model	Moisture Target Series 6
Category	Measuring Instruments
Language	English