GE Moisture Target Series 6 User Manual

Chapter 3. Operation and Programming
Moisture Target Series 6 Hygrometer User’s Manual 59
3.6.3 Setting Autocal
Note: To enter the Autocal Settings menu, you must be using a standard
M Series probe. If a VeriDri probe is being used, AutoCal is not
necessary and will not be accessible.
To change the Autocal settings, from the
Settings Menu select AutoCal and press
Enter . The following screen appears.
To change the Autocal interval settings,
select Interval and press Enter . A screen
similar to the following appears.
Use the left and right arrow keys to select
each digit to be changed and the up and
down arrow keys to increase or decrease its
value. Press Enter to save (or Cancel
to keep the previous value), and return to the
AutoCal Settings menu.
To accept or reject AutoCal, select Cal Now
and press Enter . A screen similar to the
following appears.
To accept AutoCal, select Yes. To reject
AutoCal select No. Press Enter to
confirm your selection and return to the
AutoCal Settings menu.

GE Moisture Target Series 6 Specifications

General

Brand	GE
Model	Moisture Target Series 6
Category	Measuring Instruments
Language	English