Chapter 5. Specifications
Moisture Target Series 6 User’s Manual 87
5.1 Electronics (cont.)
Temperature:
operating: –20° to +60°C
storage: –40° to +70°C
Warm-Up Time:
meets specified accuracy within three minutes
Dimensions:
panel-mount: 2.24 x 4.09 x 4.79 in. (H x W x D)
(57 x 104 x 121.78 mm)
cutout required: 1.81 x 3.69 in. (H x W)
(46 x 93.6 mm)
board-mount: 5.9 x 5.1 x 2.2 in. (H x W x D)
(150 x 130 x 56 mm)
European Compliance:
complies with EMC Directive 2004/108/EC and 2006/95/EC Low
Voltage Directive (Installation Category II, Pollution Degree II)
5.2 Moisture Measurement
Sensor Type:
thin-film aluminum oxide moisture sensor probe
Moisture Probe Compatibility:
compatible with all GE M-Series aluminum oxide moisture probes and
VeriDri transmitters
Traceability:
All moisture probe calibrations are traceable to National Institute of
Standards and Technology (NIST) standards or National Physical Lab,
U.K. (NPL) as accredited by Irish National Accreditation Board
(INAB).
To Next Page
Loading...
Need help?
General
