4–12 489 GENERATOR MANAGEMENT RELAY – INSTRUCTION MANUAL
CHAPTER 4: INTERFACES
FIGURE 4–3: Communications using Rear RS485 Port
4.2.3 Installing the EnerVista 489 Setup Software
The following minimum requirements must be met for the EnerVista 489 Setup software to
operate on your computer.
• Pentium class or higher processor (Pentium II 400 MHz or better recommended)
• Microsoft Windows 95, 98, 98SE, ME, NT 4.0 (SP4 or higher), 2000, XP
• Internet Explorer version 4.0 or higher (required libraries)
• 128 MB of RAM (256 MB recommended)
• Minimum of 200 MB hard disk space
A list of qualified modems for serial communications is shown below:
• US Robotics external 56K Faxmodem 5686
• US Robotics external Sportster 56K X2
• PCTEL 2304WT V.92 MDC internal modem
After ensuring these minimum requirements, use the following procedure to install the
EnerVista 489 Setup software from the enclosed GE EnerVista CD.
Courtesy of NationalSwitchgear.com
To Next Page
Loading...
