GE Multilin 745

A3 Event Recorder
745
Transformer Management Relay
Actual Values
http://www.GEindustrial.com/multilin
6–13
GE Multilin
b) Energy Data Clear
PATH: ACTUAL VALUES !" A2 METERING !" ENERGY ! ENERGY DATA CLEAR
To clear all energy data, set CLEAR MAX DEMAND DATA to “Yes”. The last date and time
that the energy data were cleared are also displayed. If the date has never been
programmed, the default values shown above appear.
c) Windings 1 to 3 Energy
PATH: ACTUAL VALUES !" A2 METERING !" ENERGY !" W1(3) ENERGY
The source and load watthours and varhours are displayed for Winding 1. These
messages are repeated for Windings 2 and 3.
A3 Event Recorder
Event Data Clear PATH: ACTUAL VALUES !" A3 EVENT RECORDER ! EVENT DATA CLEAR
Enter “Yes” for the CLEAR EVENT DATA RECORDER to clear all event recorder data. The
CLEAR EVENT RECORDER SIGNAL actual value assigns a Logic Input to be used for
remote clearing of the event recorder. The last date and time the demand data were
cleared are also displayed. If the date has never been programmed, the default
values shown above appear.
! ENERGY DATA [!]
CLEAR
CLEAR ENERGY
DATA? No
MESSAGE
DATE OF LAST CLEAR:
Jan 01 1996
MESSAGE
TIME OF LAST CLEAR:
00:00:00
! W1 ENERGY [!] W1 SOURCE WATTHOURS:
0 MWh
MESSAGE
W1 LOAD WATTHOURS:
0 MWh
MESSAGE
W1 SOURCE VARHOURS:
0 Mvarh
MESSAGE
W1 LOAD VARHOURS:
0 Mvarh
! EVENT DATA [!]
CLEAR
CLEAR EVENT DATA
RECORDER? No
MESSAGE
CLEAR EVENT RECORDER
SIGNAL: Disabled
MESSAGE
DATE OF LAST CLEAR:
Jan 01 1996
MESSAGE
TIME OF LAST CLEAR:
00:00:00.000
MESSAGE
NO. OF EVENTS SINCE
LAST CLEAR: 0