NX-10 Installers manual
211
Term Definition
RF Sensor Lost and
Restores
A Reporting setting that sends a report to the selected report control when an RF sensor is missing. A
restore report is sent to the central station when the receiver receives a valid signal from the lost
transmitter.
RSSI Received Signal Strength Indicator. This indicates the field signal strength of the NX-7002.
RSSI in test call A Reporting menu entry that adds the RSSI strength into the test report.
RSSI Value
Received Signal Strength Indication Value. This is a measure of the RF reception and is similar to the
indication on a mobile phone.
An Options setting that displays the current RSSI value. The RSSI value is periodically updated when
logged into the network. RSSI values range from 0 to 31 with 99 as unknown.
S
Secondary reporting The means of reporting events that the control panel fails to report.
Sending SMS
An Options menu option that indicates that the module is sending an SMS message over the GSM
network.
Serial Number
An Options setting that displays the serial number of the GSM modem used by the NX-7002. It is used
for diagnostics only.
SIA Securities Industry Association (reporting protocol).
SIA Comb’d Evts
A menu entry that sets SMS reporting options so that events for separate account codes can be sent
in the same message.
SIA partition mods A menu entry that allows partition modifiers to identify partitions.
SIA Single Evts
A menu entry that sets SMS reporting options so that events are grouped and sent as separate
messages to separate account codes.
SIM card PUK code See PUK code
SIM PIN Accepted An Options setting that indicates that the PIN number for the SIM card has been entered correctly.
SIM PIN Code An Options setting that configures the code used to enrol the SIM card on the GSM network.
SIM PUK Required
An Options setting that indicates that the SIM card has been blocked and a PUK code must be
entered to unblock it. Put the card into a mobile phone and enter the PUK code. When the card has
been unblocked put it back into the GPRS module.
Siren/Line Cut and
Restores
A Reporting setting that sends a report to the selected report control when a siren or phone fault
occurs. A restore report is sent when the fault is fixed.
Site Address A Reporting menu option that contains the site address.
Site Initiated
An Up/download setting that allows an upload/download session between the NX-7002 and the PC
to be initiated from a keypad.
SM PSU Trouble
An Options setting that indicates that there is a problem with its 3.8 V Switched Mode Power Supply
Unit.
SMS Short Message Service (SMS) is a service for sending short text messages to mobile phones.
SMS Reporting A Reporting menu entry that groups SMS reporting options.
SMS Service Centre
Address (SMCS)
An Options setting that configures the SMS service centre phone number. Usually, this number
should be left blank as it is dialled automatically by the SIM card. It should include the country code.
Software Revision An Options setting that displays the current software version of the GSM engine.
Speed
An Options setting that configures the baud rate for CSD/GSM download. This setting must match the
baud rate set on the PC modem.
To Next Page
Loading...
Need help?
General
