Term Definition
Status Check
An Options menu entry that groups status messages for GSM events. See chapter 5 for more
information on status messages.
System Control An Options menu entry that groups together HomeText system settings.
T
Tamper/Fault
A Reporting menu entry that groups together the tamper and trouble events that are reported to the
selected report control.
Tampers and
Restores
A Reporting setting that sends a report to the selected report control when a tamper occurs. A report
is also sent when the tamper is no longer active.
TCP/IP Alarm Port
An Options setting that configures the number of the TCP/IP port to which polling and alarms are
reported. The default is 9999 and under normal circumstances should not be changed.
TCP/IP Reporting A Reporting menu entry that groups TCP/IP reporting options.
Test Reports
A Reporting setting that sends a test report to the selected report control at pre-programmed
intervals. The units can be set in days or hours.
Traceability
A menu entry that groups additional information, like serial number, manufacture date, and firmware
revision.
Transparent mode
An operating mode for CSD on a GSM network. Data is transferred directly from one modem to
another modem.
Type An Options setting that displays the type of GSM modem used by the NX-7002.
U
U/D Authentication
Disable Time
An Up/Download setting that contains the length of time for which the system is disabled after the
maximum number of authentication attempts has been exceeded.
U/D Call Back after
Voice Call
An Up/Download setting that starts an up/download session after a voice call.
U/D Port An Options setting that indicates that configures the port for GPRS up/download.
Up/Download
A menu entry that groups options used to control download sessions between the up/download
software and the control panel.
Upload The process of retrieving information from a PC running the upload/download software.
Use V1.110
An Options setting that enables V.110 for site-initiated CSD GSM calls. Enable this setting if the PC is
on an ISDN line and is using an ISDN modem.
User ID
An Options setting that configures the user ID for a PAP login. Contact the network provider to
confirm if a PAP login is required and to obtain the user ID and password.
Using GSM Audio
An Options setting that indicates that the module is using GSM audio. The GSM audio channel is used
when the panel reports through the voice channel of the GSM network.
Using GSM CSD An Options setting that indicates that the module is using GSM CSD.
See also CSD
V
Version A menu option that displays the current software version of the GPRS module.
X
XSIA
Extended Securities Industry Association (reporting protocol). This adds a zone or user name when
appropriate to the report.
Z
To Next Page
Loading...
Need help?
General
