GE PGS908 Technical Service Guide

– 36 –
Carefully remove the tubes from the valve. 7.
Remove the 1/4-in. hex-head screw that 8.
attaches the valve to the range.
Note: When installing the lockout valve, be sure that
the cutout in the bottom of the valve is engaged
behind the tab on the back of the range.
Tab
Cutout
Disconnect the wires from the lockout valve.5.
Using an 11/16-in. wrench, disconnect the inlet 6.
and outlet tube hex-head nuts from the valve.
Cover
Disconnect
Wires
Lockout
Valve
To remove the lockout valve:
Remove the oven door. (See 1. Oven Door Removal.)
Remove the range from the installation. (See 2.
Range Removal.)
Remove the rear cover. (See 3. Rear Cover Removal.)
Remove the two 1/4-in. hex-head screws and 4.
the lockout valve cover.

GE PGS908 Specifications

General

Brand	GE
Model	PGS908
Category	Ranges
Language	English