GE VAT2000

4. Operation Panel (Keypad)
4-10
(Continued from previous page)
Block-B Parameter Mode
: Parameters changed infrequently during the normal usage
Basic function settings
Output rating (B01-0~9)
Motor circuit constant (IM) (B03-0~5)
Ratio interlock setting (B06-0, 4~6)
Extended function setting
Acceleration/deceleration time (B10-0~5)
Program frequency setting (B11-0~8)
Digital setting (B13-0~7)
Dead band setting (B14-0)
Machine time constant setting (B15-0)
Overcurrent limit (B18-0~6)
Output rating (dual drive) (B20-0~5)
Frequency setting (dual drive) (B21-0~1)
Acceleration/deceleration time (dual drive) (B22-0~3)
Torque boost (dual drive) (B23-0~1)
DC brake (dual drive) (B24-0~1)
Overcurrent limit (dual drive) (B25-0~1)
Speed control extended function (B30-0~8)
Vector control compensations (B32-1, 2, 4)
Voltage control constant (PM) (B35-0~5)
Demagnetising current table (PM) (B36-0~4)
Software option function settings
Software option application (B40-0~1)
Program ramp - acceleration (B41-0~7)
Program ramp - deceleration (B42-0~7)
PID Control (B43-0~4)
Multi-pump control (B44-0~3)
Traverse run (B45-0~6)
Pattern Run (B50-0~B59-3)
(Continued on next page)
Fig. 4-4 (2) Parameter configuration
knob
or
key