Service Adjustments
6-6 Venue 50 – Basic Service Manual
5447566-100 English Rev. 7
Adjust Monitor on Docking Station/Cart (continued)
Be sure to lock the wheels before adjusting the Docking Cart
height.
When the cart handles are used for power cable management,
the sudden raising of the cart to a higher position may cause
the AC plug to break.
When adjusting the cart while scanning, the power cord and
wheels may become entangled causing cable damage.
Damage to the probe cable may result if the brake pedal
catches the cable and pulls it tight against the base leg. This
puts stress on the probe and connector while in the holder.
To Next Page
Loading...
