GE Venue 50 - Connecting Probes; Completing the Setup

Completing the setup
Venue 50 – Basic Service Manual 3-25
5447566-100 English Rev. 7
Connecting probes
Connect a probe
NOTE: It is not necessary to turn OFF power to connect or disconnect a
probe.
CAUTION
Do not allow the probe head to hang freely. Excessive impact
to the probe will result in irreparable damage.
CAUTION
To prevent probe connector pins damage, or PCB board
damage, do not use excessive force when connecting the
probes.
CAUTION
Keep the probe cables away from the wheels.
Do not bend the probe cables.
Do not cross cables between probes.