ActionStep
Immediately close all clamps after removing the wrap from each component.4
Lay the bag assembly flat on the table and inspect the disposable bag.
Verify that the disposable bag has no tears, rips or cuts.
Note:
Light scratches and creases may be present on the bag due to handling. These
and similar imperfections do not indicate failed bag integrity.
5
Verify that the clamps on all lines are closed.6
Carefully, turn over the bag assembly and remove the bubble wrap and
foam from the impeller baseplate.
7
Remove any additional wrapping at the top of the disposable bag.8
Result: The disposable bag assembly is ready to be installed into the vessel.
Dispose of the box according to local procedures.9
146 Xcellerex XDM 50-1000, XDUO 100-1000 mixers Operating Instructions 29251615 AD
6 Preparation
6.3 Prepare the disposable bag
6.3.1 Unpack the disposable bag assembly
To Next Page
Loading...
Need help?
General
