GE XDP-H2 - Page 54

Setup and Calibration 4-25
January 2008
Viewing and Clearing the
Cal Drift (cont.)
Note: The “Manual Cal” menu option also appears on the above list.
Press
[ESC] as many times as necessary to return to normal RUN mode,
or proceed to the appropriate section of this chapter to continue
programming the XDP.
Range
Cal
Use the [S] and [T] keys to
select
[View Cal Drift] and press
[ENTER].
View-Cal-Drift
Clear-Cal-Drift
View-Cal-Drift Both the zero and span drift
values, in mA, are shown.
Press the
[ENTER] key when
you are ready to continue.
Zero Drift x.xx
Span Drift x.xx
OK
Range
Cal
Use the [S] and [T] keys to
select
[Clear Cal Drift] and press
[ENTER].
View-Cal-Drift
Clear-Cal-Drift
Clear-Cal-Drift Use [
W] and [X] highlight the
desired answer (YES or NO)
to the question shown. Then,
press the
[ENTER] key.
Clear Drift? Warning
Data Will Be Reset!
YES
NO
Range
Cal
Press [ESC] to return to the Cal
Menu.
View-Cal-Drift
Clear-Cal-Drift