Advanced Programming 5-11
January 2008
The Low Low Alarm (cont.) The program alternates between the two previous prompts, each time
[ENTER] is pressed. To leave the test loop, press [ESC].
Note: Upon leaving the test loop, the alarm is automatically reset to
its normal state.
To continue programming the setup menu, proceed to the appropriate
section for instructions. Otherwise, press
[ESC] four times to return to
live measurement mode.
Ala..Low-Low-Alarm Use the [
S] and [T] keys to
select
[Fail-Safe] and press
[ENTER].
Trip-Point
Test
Fail-Safe
Alarms..Fail-Safe Use the [
S] and [T] keys to
select desired alarm type and
press
[ENTER].
Non-Fail-Safe
Fail-Safe
Ala..Low-Low-Alarm Press the [ESC] key to leave the
“Low Low Alarm” submenu.
Trip-Point
Test
Fail-Safe
Alarms Press
[ESC] to return to the
setup menu.
Low-Alarm
Low-Low-Alarm
Normal-Alarm
To Next Page
Loading...
Need help?
General
