GE XMO2

Advanced Programming 7-23
September 2007
TERMINAL Option (cont.) • The DriftCal Span Error is generated when an error occurs during
a span gas (two-gas) calibration.
• The Gas Input Underrange Error is generated when the main gas
(oxygen) mV signal drops below -512 mV.
• The Gas Input Overrange Error is generated when the main gas
(oxygen) mV signal exceeds 512 mV.
ENABLE/DISABLE ERRORS
Press [N] to skip this error, or
press
[Y] or [Enter] to set it.
DriftCal Span Error?
DriftCal Span Error response:
Press [N] to select the desired
option, then press
[Y] or [Enter] to
confirm your selection and move
to the next prompt.
disable [ENABLE]
ENABLE/DISABLE ERRORS
Press [N] to move on to the next
error.
DriftCal Span Error?
ENABLE/DISABLE ERRORS
Press [N] to skip this error, or
press
[Y] or [Enter] to set it.
Gas input underrange?
Gas input underrange response:
Press [N] to select the desired
option, then press
[Y] or [Enter] to
confirm your selection and move
to the next prompt.
disable [ENABLE]
ENABLE/DISABLE ERRORS
Press [N] to move on to the next
error.
Gas input underrange?
ENABLE/DISABLE ERRORS
Press [N] to skip this error, or
press
[Y] or [Enter] to set it.
Gas input overrange?
Gas input overrange response:
Press [N] to select the desired
option, then press
[Y] or [Enter] to
confirm your selection and move
to the next prompt.
disable [ENABLE]
ENABLE/DISABLE ERRORS
Press [N] to move on to the next
error.
Gas input overrange?