SHENZHEN GETECH TECHNOLOGY CO,.LTD
host will use this to limit your moves and to check, if your models fit onto the print bed. You can also define
the position of the x and y end stop.
Recommended settings:
Printer type: Rostock printer
Home X：0 Home Y：0 Home Z：Max
Printable Radius:100mm
Printable Height:220mm
(In case the motor direction is wrong, we’d better set the print height as 220mm to avoid clash of the
hotend to the platform)
So far the setting of Rostock 301 is finished.
To Next Page
Loading...
