Geeetech Rostock 301 - Function Testing and Operation; Repetier Host and Component Tests

SHENZHEN GETECH TECHNOLOGY CO,.LTD
14
5. Function Testing
The firmware of Rostock 301 is already uploaded based on Windows 7 operating system, and we have done
debugging to make sure that every part of it can work normally. However, there may be unpredictable
factors during transportation . Please do the following simple test before using it.
5.1 Repetier-Host Test
5.1.1 Motor Test
Before the test, manually place the carriage of X / Y / Z axis at the intermediate position of each axis to
avoid accidental collision during the test. There is emergency stop button on the top right corner , or you
can cut off the power directly if anything went wrong. Be prepared for emergency stop.
Open Repetier host and connect the printer. Turn on the power supply. Connect the printer.
Click Home button , then the three axes will move towards the endstop in turn . After they touch the
endstop they will move back for a short distance and then stop the movement.