SHENZHEN GETECH TECHNOLOGY CO,.LTD
1. Check Power Supply
Rostock 301 uses DC12V, 29A power supply, choose 110V or 220V according to national power using
standard. Please make sure that the voltage of the power supply conforms to current national power using
standard.
2. Software Resources
2.1 Repetier-Host
The Repetier-Host is a simple to use host software, which is be compatible with most firmware around. You
can add and position your STL files on the simulated print bed and slice them all together. For slicing you
can use the built-in Slic3r slicer. Just call "Slice & Load" and the job gets delegated to the current slicer,
showing its output in the log window.
Download the Repetier host V 1.6.0 here.
For detailed information of Repetier Host please refer to our wiki.
For detailed using methods of the slicing software, slic3r, which comes with Repetier Host, please also refer
to our wiki.
2.3 Firmware resources
Rostock 301 uses GTM32 control board; you need to use STM32 ST-LINK Utility to upload/refresh the
firmware.
To Next Page
Loading...
Need help?
General
